LicBund 5/8" to 3/4 Inch W/Step Key Gas Engine Pulley Crank Shaft Sleeve Adapter Pulley Bore Reducer Bushing Sheave & Key Predator

This is what you use to install a vertical shaft pressure washer pump on a Hortzontal shaft engine and it works perfectly

It does what it’s supposed to do. But I highly recommend putting it on and turning the motor on and holding a piece of sand paper on it. Until your pulley slides on with little resistance, or you will never get it off again. I also had to cut my key down to about 5/8 of an inch to get this to work with my torque converter.

It was what I needed. Fit like it should.

it fits

It’s held up so far on my Coleman CT200. Needed a little trim and ground it down for the torque converter, so keep that in mind.

Worked!

Needed to increase the shaft of a motor for an old application on a tank farm, fit the bill perfectly and so far has served the purpose at a fraction of the cost of other options

Just what I needed for my mini bike. Make sure you measure the output shaft when you purchase a torque converter.