microtivity IS608 10-Segment LED Display (1 Red and 1 Green)

I'm using these with a Raspberry Pi pico and cascaded I2C modules. Reading the status of 16 different pins, so two of these 10-segment displays give me the output I need with a few LEDs left over. All LEDs seem to be working and are much more compact that 16 separate LEDs. As you can see they fit well on a breadboard.

Works excellently but if you don't need two colors you can buy in bulk from other suppliers for far less.

These 10-segment displays offered by Microtivity have exceeded my expectations. I purchased this item nearly three years ago, and to date, they have yet to fail. Both units remain equally lit, with the same vibrant colour they began with.However, please note before implementing the displays into your project that they operate at different voltages, so a bit of probing will be required before use. One of the units received operates at 1.3v, while the other operates at 2.6v.This being my only complaint, if you're in the market for easy-to-implement standard displays, these buggers are likely your best bet.

Look good, surprisingly rugged (I've put them through a lot).Wish a model existed with a common cathode, but it's not too hard to bridge one side.

These work as expected. I would have like the green ones to be a bit brighter though.

Missing one LED segment. Nice and bright though. Fortunately I had a spare.